EFace10 User Manual
Page | 10 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
Standby Interface 1.3
After connecting the power supply, the following standby interface is displayed:
Click to enter the User ID input interface.
When there is no Super Administrator set in the device, tap to go to the menu.
After adding a Super Administrator on the device, it requires the Super Administrator’s verification
before entering the menu functions.
NOTE: For the security of the device, it is recommended to register super administrator the first
time you use the device.
★The punch state options can also be displayed and used directly on the standby interface. Tap
anywhere on the screen apart from the icons, and six shortcut keys appears on the screen, as
shown in the figure below:
Press the corresponding punch state key to select your current punch state, which is displayed in
green.
NOTE: The punch state options are off by default and need to be changed to other option. Refer
"7.4
Punch States Options" in order to get the punch state options on the standby screen.
To Next Page
Loading...
Need help?
General
