EFace10 User Manual
Page | 52 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
15 Connect to ZKBioSecurity Software
Set the Communication Address 15.1
Device side
1.
Tap COMM. > Ethernet in the main menu to set the IP address and gateway of the device.
(Note: The IP address should be able to communicate with the ZKBioSecurity server, preferably in
the same network segment with the server address)
2.
In the main menu, click COMM. > Cloud Server Setting to set the server address and server port.
Server address: Set the IP address as of ZKBioSecurity server.
Server port: Set the server port as of ZKBioSecurity (The default is 8881).
Soft
ware side
Login to ZKBioSecurity software, click System > Communication > Communication Monitor to set the
ADMS service port, as shown in the figure below:
Add Device on the Software 15.2
Add the device by searching. The process is as follows:
1. Click Attendance > Attendance Device > Device > Search, to open the Search interface in the
software.
To Next Page
Loading...
Need help?
General
