Setting the limiter
The limiter can prevent distortion by reducing input signals that have excessively high levels.
When the limiter is ON, if the input signal level exceeds the set threshold value, the input signal level will be sup-
pressed to prevent the sound from distorting.
The amount of time after the input signal exceeds the threshold until compression of the output signal is maxi-
mized is called the “attack time”. The amount of time after the input signal goes below the threshold until the lim-
iter stops compressing the signal is called the “release time”. Change these two to adjust the audio quality.
Attack
Level
Signal after
limiter
Release
1. Press .
This opens the Menu Screen.
2. Use and to select "Input/Output", and press .
40
To Next Page
Loading...
Need help?
General
Weight and Dimensions
