Zoom H3-VR - Page 43

Ӎ
Setting the attack time
This sets the amount of time after the input signal exceeds the threshold until compression of the post-limiter
signal is maximized.
4. Use and to select “Attack Time", and press .
5. Use and to set the attack time.
HINT
• This can be set from 1 to 4 ms.
Ӎ
Setting the release time
This sets the amount of time until compression of the post-limiter signal stops after the input signal goes below
the threshold.
4. Use and to select “Release Time", and press .
43