Zoom R20 - Powering the R20 On;Off

Turning the power on/off
Turning the power on
1. Confirm that the output devices connected to the R20 are turned off.
2. Set all knobs and faders to their minimum values.
3. Set to ON.
This turns the R20 power on, opening the Projects Screen (→ Opening projects ) or Home Screen (→
Home Screen overview) on the touchscreen.
The first time the power is turned on after purchase, as well as after the R20 has been reset to factory
defaults, the Date/Time Setting Screen will open. Set the date and time when it does. (→ Setting the
date and time (first time starting up)
）
4. Turn on the output devices connected to the R20.
NOTE:
• The power will automatically turn off if it is unused for 10 hours. To keep the power on at all times,
disable the automatic power saving function. (→ Setting the Auto Power Off function)
• If “No SD card!” appears on the display, confirm that an SD card is inserted properly. (→ Inserting SD
cards)
• If “Invalid SD card!” appears on the display, the card is not formatted correctly. Format the SD card (→
Formatting SD cards) or load a different SD card (→ Inserting SD cards).
25