Changing the snap setting
The snap setting used for the entire project can be changed.
If this is “On”, notes and regions will be aligned to ruler increments when moved (→ Control Bar overview).
1. On the Project Settings Screen, tap “On” or “Off” for “Snap”.
Setting Explanation
Off This turns off the snap function.
On This turns on the snap function.
Setting the project volume
Use this to adjust the project volume for output from the OUTPUT jacks.
1. Slide the Output Level slider or tap and on the Project Settings Screen.
The set volume is shown above the slider.
NOTE:
This can be set from 0 to 100.
42
To Next Page
Loading...
