Adjusting effect parameters
1. Tap the effect you want to edit on the patch memory Edit Screen (→ Opening the patch memory Edit
Screen).
This opens the Effect Settings Screen.
2. Adjust the effect.
❶
Return to the patch memory Edit Screen
❷
Replace effect
Tap this to open the Effect List Screen. Tap the desired effect to select it.
❸
Turn effect on/off
Tap this to turn the effect on/off.
❹
Effect adjustment parameters
Slide the patch memory sliders or tap and to adjust the parameters.
NOTE:
• Three effects can be combined as desired in a patch memory. If the processing capability limit is
exceeded, however, a “Process Overflow” warning will appear and effects will be bypassed. Change one of
the effects to end this condition.
• The parameters that can be adjusted depend on the effect.
63
To Next Page
Loading...
