Adjusting waveform display size
1. Adjust the waveform display size.
Use the input level slider for the desired channel to adjust its waveform display size so that the input
signal waveform is easy to view.
HINT:
• The sizes of the recording waveforms shown in DAW applications will be about the same size as those
shown here.
• Using the input level sliders will change the amplification of the input signals, but this will not degrade
recording quality.
NOTE:
• When using a DAW app that does not support 32-bit float recording, input exceeding a certain level could
cause distortion. If this occurs, the waveform size can be reduced to avoid this.
• A list of applications that have been checked for compatibility with 32-bit float recording is available on
the ZOOM website (zoomcorp.com).
30
To Next Page
Loading...
