RT100 Rough Terrain Crane 07 -
11
the 2 front (or rear) outrigger switches to the “JACK” position.
1 Push and hold the outrigger extend / retract master switch to the
2 After the 4 outriggers hold the weight of the crane (wheels off the
ground), release the master switch. The switch moves to the neutral
1 Look at the bubble level to tell if the crane is at level.
2 If the bubble indicator does not show a level indication, you can move
each outrigger to make the crane level.
If the crane is low on the right front, do the steps that follow:
1 Push the right front outrigger switch to the “JACK” position.
2 Push the outrigger extend / retract master switch to the “EXTEND”
position at the same time.
3 Monitor the bubble indictor. When the bubble is at the correct position,
f) Install the outrigger retaining pins.
(2) Retract the outrigger.
Retract the boom and attach it to the support before you retract the
a) Remove the outrigger beam retaining pins.
b) Push and hold 2 front (or rear) outrigger switches to the “JACK” position.
1 Push the outrigger extend / retract master switch to the “RETRACT”
position at the same time.
2 After the 2 front (or rear) outrigger jacks fully retract, release the master
switch. The switch moves to the neutral position automatically.
3 Do this step until all 2 front (or rear) outrigger jacks are retracted.
c) Push an outrigger switch (1 of 4) to the “BEAM” position.
1 Push the outrigger extend / retract master switch to the “RETRACT”
position at the same time.
2 After the outrigger retracts fully, release the master switch. The switch
moves to the neutral position automatically.
3 Do this step until all 4 outriggers are retracted.
d) Install the outrigger retaining pins.
To Next Page
Loading...
