RT100 Rough Terrain Crane 07 -
19
Do not use the bypass key switch when you do usual crane operations.
Choose the correct line parts for the boom length and load weights. If
the hook turns because of the rope, put the load on the ground. Do not
lift the load until the rope is straight.
When you lift a load to a height that is more than usual, monitor the
number of wire-rope wraps remaining on the winch. If the load is
lowered down a hole that is deep, monitor the wire-rope. Keep a
minimum of 3 wraps of rope on the winch while you operate the crane.
Lift the load vertically. Do not try to lift the load diagonally. Do not pull
a load across the ground.
Monitor the area as you lift a load. Do not move a load unless the
Do not derrick the boom up and extend the boom at the same time if:
The crane has a part of the load weight
The crane is connects to a load on the ground.
Do not change quickly between reel-off and spool-up. Let the winch
stop before you continue to move the hook.
Do not try to lift a load that weighs more than the lift capacity of the
Do not use the crane to lift personnel.
To Next Page
Loading...
