Zte H1600 - Page 42

34
SJ-20210621164956-008 | 2022-09-01(R1.3)
ZTE H1600 Maintenance Management Guide
Figure 4-14 IP Filter Page
2. Configure the IP filter configuration parameters, see Table 4-6.
Table 4-6 Parameter Descriptions for the IP Filter
Parameter
Description
On/Off
Set radiobox On to enable the function of IP filter.
Name
Name of the IP filter item.
The name must be specified.
Target
Specify to discard or permit the data packages.
Rule Priority
Specify the value to modify the service priority.
IP Version
The IP version includes:Any, IPv4 , IPv6.
Source IP/Destination IP
The source/destination IP address.
Protocol
Select the protocol that needs to filter packets.
By default, it is Any.
Ingress
Specify the data traffic direction. The Ingress option and
egress option cannot be the same.
⚫
If the ingress is LAN, the egress should be a WAN or LTE
connection. The data traffic direction is upstream.
⚫
If the ingress is a WAN or LTE connection, the egress
should be the LAN. The data traffic direction is down-
stream.