5 Configure the Local Network
Table 5-4 Access Control-Mode configuration parameters
Parameter Description
No Filter No filter is to be applied (the default).
Black List Deny LAN users to access specific address.
White List Allow LAN users to access specific address.
4. Click Apply button to apply the changes.
Access Control-Rule Configuration
5. Click Access Control-Rule Configuration to the configuration page, see Figure
5-6.
Figure 5-6 Access Control-Rule Settings
6. Configure the access control-rule configuration parameters.Table 5-5 lists the access
control-rule configuration parameters.
Table 5-5 Access Control-Rule Configuration parameters
Parameter Description
Name The name of access control item.
MAC Address The MAC address of the wireless device.
We suggest to set the MAC addresses in access control list
using a wireline connected device.
Modifying the list using a wireless device may cause unex-
pected disconnection of the device used.
SSID
SSID name corresponding to the wireless network that the
rule is applied to. The default value is Wi-Fi 2.4GHz&5GHz.
7. Click Apply button to apply the changes.
SJ-20210621164956-009 | 2021-12-07(R1.0) 47
To Next Page
Loading...
