5 Configure the Local Network
Figure 5-16 RA Service Page
14.Configure the RA service parameters.Table 5-13 lists the RA service parameters.
Table 5-13 Parameter Descriptions for the RA Service
Parameter Description
RA Service Enable or disable the RA service function.
Specify MTU If On button is selected, enter the MTU value.
MTU Define the maximum transfer unit.
Preference By default, the preference is Middle.
Min Retry Interval
The minimum time allowed between sending unsolicited multi-
cast Router Advertisements from the interface. (The value must
not be greater than 0.75 × (Maximum Retry Interval )).
Max Retry Interval
maximum time allowed between sending unsolicited multicast
Router Advertisements from the interface.
M
Managed flag.
Select this check box to enable the connected devices to obtain
the IPv6 address through DHCP IPv6.
O
Other configure flag.
Select this check box to enable the connected devices to obtain
DNS address through DHCP IPv6.
Prefix Delegate Type
AutoSense: All the available prefixes will be delegated.
Manual: One or more prefixes selected manually from all the
static prefixes configured before will be delegated.
15.Click Apply button to apply the changes.
SJ-20210621164956-009 | 2021-12-07(R1.0) 55
To Next Page
Loading...
