Zte MF29A - Page 25

25
• Wi-Fi On/Off: Enable Wi-Fi or not.
• Network Mode: If all of the wireless devices connect with this
router in the same transmission mode, performance will be
improved by choosing the appropriate wireless mode.
• Network Name(SSID): Service Set Identifier (SSID). Enter a
string less than 32 characters as the name for your wireless local
area network (WLAN).
• Broadcast Network Name(SSID): Disable or Enable (Default)
this function. If Enable is selected, the router broadcasts the
SSID, and other devices can detect and connect to it. If Disable
is selected, the other devices cannot detect the router. You can
only connect to the router by manual setting.
• AP Isolation: When Enabled is selected, each of your wireless
clients will not be able to communicate with each other. When
Disable is selected, each of your wireless clients will be able to
communicate with each other.
• BSSID: MAC address of the Wi-Fi.
• Frequency(Channel): Choose the appropriate channel to
optimize the performance and coverage of your wireless
network.
• WDS Mode: WDS mode make the router to communicate with
other APs, WDS connection is two-way communication, APs
should know each other’s wireless MAC address. And make sure
that all APs share the same SSID and channel.
WDS conguration is shown below:
Step Description
1. Set the SSID and
the same channel for
APs
Manually set the SSID and the same channel
is strongly recommended.