2 Product Overview
Table 2-2 Descriptions of Indicators
LED Indicator Status Description
Off The device is powered off.
Solid green The device is powered on properly.
Power
Solid red
The device is performing self-detection or the self-detec-
tion fails.
Off
The equipment is not powered on or the WAN port is
disabled.
Broadband
(WAN)
Solid green The Ethernet connection has been established.
Off The gateway is switched off.
Solid green
The WAN connection is online. The device has a WAN
IP address from IPCP, DHCP or statically configured.
LED remains green in the case of disconnection due
to idle timeout when PPP dial-on-demand is enabled.
Green LED indicates that the routing connection state is
up.
Solid red
The WAN connection is dialing up or fails to get online.
Device attempted to become IP connected and failed (
no DHCP response, no PPPoE response, PPP authenti-
cation failed, no IP address from IPCP, etc).
Internet
Flashing green
The Internet connection has been established and the
data is being transmitted or received.
Off WLAN RF switch is off.
Solid green WLAN RF switch is on.
2.4G
Flashing green
WLAN RF switch is on and the data is being transmitted
or received, and the flashing frequency indicates Wi-Fi
network traffic.
Off WLAN RF switch is off.
Solid green WLAN RF switch is on.
5G
Flashing green
WLAN RF switch is on and the data is being transmitted
or received, and the flashing frequency indicates Wi-Fi
network traffic.
Off
No WPS access or the WPS access of the terminal ex-
ceeds 5 minutes.
WPS
Solid green
WPS access is successful. This solid-on light will be au-
tomatically off after 5 minutes.
SJ-20201203151144-003 | 2021-06-16(R1.0) 7
To Next Page
Loading...
