ZXHN H3600 Maintenance Management Guide
Parameter Description
DHCPv6: The device acquires a global address through
DHCPv6. If no option is selected, it indicates that no address
acquisition mode is configured.
PD: You need to set a static IPv6 address.
SLAAC: The device generates a global address in accor-
dance with the RA packets from the upper-layer server.
GUA Mode of obtaining global address.
Gateway It is usually the IPv6 address of the ZXHN H3600 device by de-
fault.
PD Prefix Delegation.
DNS1–DNS3 IPv6 address of the DNS server for static connections. You can
set up to three IPv6 addresses for the server. These IPv6 ad-
dresses are provided by the ISP.
VLAN
Specifies whether to carry a VLAN tag in the packets sent over
the WAN connection. By default, On button is not selected. If it
is selected, a VLAN tag is carried in the packets sent over the
WAN connection, and the VLAN ID must be set.
VLAN ID
Identifies a VLAN. Range: 0–4094. To ensure normal service op-
eration, the VLAN ID must be the same as that set in upper-lay-
er MDU configuration.
Note
In the ZXHN H3600 provisioning, configure only one Internet-WAN connection and
delete other WAN connections.
2. Click Apply button to apply the changes.
5.2.2 Configure the 3G
A Dongle device can be connected to ZXHN H3600 through a USB interface. If the Don-
gle has a 3G(SIM) card inserted, the ZXHN H3600 can access the Internet through the
Dongle device.
This page provides the parameters of the 3G connection configuration function.
Configuration Process
Table 5-2 lists the 3G process of configuring the WAN connection.
22 SJ-20201203151144-003 | 2021-06-16(R1.0)
To Next Page
Loading...
