Zte ZXHN H3600 - Configure the Fax

ZXHN H3600 Maintenance Management Guide
Table 7-5 Description of the Media Parameters
Parameter Description
G722, G711U, G711A, G729,
G726, G723
Select a codec, which must be the same as that configured in the
SoftSwitch system.
VAD Select a codec, which must be the same as that configured in the
SoftSwitch system.
Codec Priority You can modify priority through this parameter. A lower number
indicates a higher priority.
3. Click Apply button to apply the changes.
7.6 Configure the Fax
The ZXHN H3600 supports the T30 and T38-based fax feature. By default, the T38 pro-
tocol is used.
Steps
1. On the main page of the ZXHN H3600 device, select VoIP > Fax. The Fax page is
displayed, see Figure 7-7.
Figure 7-7 Fax Page
2. Set the parameters. For a description of the parameters, refer to Table 7-6.
Table 7-6 Parameter Descriptions for the Fax
Parameter Description
Enable T38 Protocol Whether to enable the T38 protocol.
If the Off button is selected, the T30 protocol is used.
3. Click Apply button to apply the changes
78 SJ-20201203151144-003 | 2021-06-16(R1.0)