Zte ZXHN H3600 - Configure the Security

5 Configure the Internet
2. Set the parameters.
Table 5-7 lists the QoS traffic shaping parameters.
Table 5-7 QoS Traffic Shaping parameters
Parameter Description
On/Off Click On to enable the traffic shaping function.
Click Off to disable the traffic shaping function.
Name New QoS traffic shaping name.
Interface Select an interface from the drop-down list.
Rate Committed access rate. Range: 0,8192 – 1000000000.
The shaping rate value of 0 indicates no speed limit.
3. Click Apply button to apply the changes.
5.4 Configure the Security
5.4.1 Configure the Firewall Level
The section describes how to configure firewall level.
Steps
Configure the Firewall
1. On the main page of the ZXHN H3600, select Internet > Security > Firewall to the
Firewall page, see Figure 5-14.
Figure 5-14 Firewall Page
2. Set the parameters. For a description of the parameters, refer to Table 5-8.
SJ-20201203151144-003 | 2021-06-16(R1.0) 31