Zte ZXHN H3600 - Configure the Route

ZXHN H3600 Maintenance Management Guide
6.4 Configure the Route
6.4.1 Configure the Routing(IPv4)
The section describes how to configure routing(IPv4), which provides the parameters of
route(IPv4) configuration features.
The relevant information of Internet status includes Routing Table, Static Routing and
Policy Routing.
Prerequisite
Before configuring routing(IPv4), make sure that the IPv4 WAN connection is created.
Steps
Check the Routing Table
1. On the main page of the ZXHN H3600, select Local Network > Routing > IPv4 to
the Routing(IPv4) page.
2. Click Routing Table to the configuration page, see Figure 6-17.
Figure 6-17 Routing Table Page
3. Click Refresh to refresh the information.
Configure the Static Routing
1. Click Static Routing to the configuration page, see Figure 6-18.
62 SJ-20201203151144-003 | 2021-06-16(R1.0)