Zte ZXHN H3600 - Configure the Mirror Function

ZXHN H3600 Maintenance Management Guide
Figure 8-7 Restore Configuration Management Page
2. Click Browse to select the user configuration file, and then click Restore Configura-
tion to restore the device to the user configuration.
8.4 Configure the Mirror function
This procedure introduces how to perform the mirror configuration.
If the mirror configuration is performed, the packets at the WAN side will be copied to the
specified LAN interface, and it can be used for the network analysis and troubleshooting.
Steps
1. On the main page of the ZXHN H3600, select Management&Diagnosis > Mirror
Configuration to the Mirror Configuration page, see Figure 8-8.
Figure 8-8 Mirror Configuration Page
2. Configure the mirror configuration parameters.
Table 8-3 lists the user mirror configuration parameters.
Table 8-3 Parameter Descriptions for the Mirror Configuration
Parameter Description
Mirror Click On to enable the mirror function.
Click Off to disable the mirror function.
Source Network-side WAN interface.
Destination User-side LAN interface.
3. Click Apply button to apply the changes.
84 SJ-20201203151144-003 | 2021-06-16(R1.0)