Zte ZXR10 5250 Series - Page 54

ZXR105250SeriesCongurationGuide
2.Portdiagnosis
3.Portinformationview
ConguringaPort
Theportcongurationincludesthefollowingcommands:
CommandFunction
zte(cfg)#setport<portlist>{enable|disable}Enablesordisablestheport.
zte(cfg)#setport<portlist>work-mode{fiber|
copper|auto[prefer{first-up|fiber|copper}]}
Setsthecomboporttoswitchbetweenthe
electricalmodeandtheopticalmode.
zte(cfg)#setport<portlist>phy-mode
{1000base-x|sgmii}]}
Controlsswitchoverbetween1000Mbpsoptical
portsandelectricalinternalports.
zte(cfg)#setport<portlist>speedadvertise
maxspeed
Setstheadvertisementofthemaximumportspeed
duplexinformation.
zte(cfg)#setport<portlist>speedadvertise
{speed10|speed100|speed1000}{fullduplex|
halfduplex}
Setstheadvertisementoftheportspeedduplex
information.
zte(cfg)#setport<portlist>duplex{full|half|
auto}
Setstheworkingmodeoftheporttofullduplex
orhalfduplex.
zte(cfg)#setport<portlist>speed{10|100|
1000|auto}
Setsthespeedoftheportto10Mbps,100Mbps,
or1000Mbps,orauto.
zte(cfg)#setport<portlist>mdix{auto|normal
|crossover}
Setsthelinesequenceidenticationfunction.
zte(cfg)#setport<portlist>flowcontrol{enable
|disable}
Enablesordisablestheportowcontrolfunction.
zte(cfg)#setport<portlist>description
<string>
Setsportdescriptioninformation.
zte(cfg)#setport<portlist>accept-frame{tag|
untag|all}
Setsthepackettypethattheportallowstoaccept.
zte(cfg)#setjumboport<portlist>{enable|
disable}
Enablesordisablestheportjumbofunction.
zte(cfg)#setport<portlist>pvid<1-4094>SetsadefaultportPVID.
zte(cfg)#setportstatisticsmode{ingress|
egress|both}
Setspacketstatisticsmode.
zte(cfg)#setsleep-mode{enable|disable}Enablesordisablestheportsleepmode.
zte(cfg)#createport<portid>name<string>Createsaportname.
zte(cfg)#clearport<portlist>{name|statistics|
description|multicast-filter}
Clearstheportname,portstatisticsdata,port
description,andthemulticastlterag.
5-6
SJ-20131111172707-002|2013-11-27(R1.0)ZTEProprietaryandCondential