Zte ZXR10 - Mechanical Parts; Table 2.1-2 a List of Optional Fittings of the W140 A

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge
Professional Installation Instruction Manual
2-2
Please refer to Table 2.1-2 for a list of optional fittings of the W140A.
Table 2.1-2 A List of Optional Fittings of the W140A
Name Unit Quantity Remarks
Omni antenna pc 1 8 dBi omni antenna
Directional antenna pc 1 8.5 dBi directional antenna
Directional antenna pc 1 14 dBi directional antenna
Directional antenna pc 1 21 dBi directional antenna
Antenna kit Set 1 Used for installing and fixing an omni antenna.
Installing support A Set 1
Used for roof-mounted mode (comprising a vertical
pole), applicable to install all types of antennae, and
providing an installation position for a lightning
arrester.
Installing support B Set 1
Used for pole-mounted mode (excluding a vertical
pole), inapplicable to install a directional antenna,
and an installation position for a lightning arrester
not available.
Installing support C Set 1
Used for side wall-mounted mode (comprising a
vertical pole), applicable to install all types of
antennae, but an installation position for a lightning
arrester not available. You can choose roof-mounted
mode or side wall-mounted mode as required.
Lightning arrester pc 1
If a lightning arrester is not available on the roof,
you must install a lightning arrester in an installing
support A.
2.1.2 Mechanical Parts
Mechanical parts of the W140A consist of the W140A, backplane, mounting panel and
installation fittings. Fig. 2.1-1, Fig. 2.1-2 and Fig. 2.1-3 show the mechanical structures
of W140A, backplane and mounting panel in turn.