Chapter Error! Style not defined. Error! Style not defined.
2-25
1. Making sure that the W140A is installed correctly, the cable connections are
correct, and the water-proof and lightning protection measures are in place.
2. Checking the W201P power supply, to ensure that the power connections are
correct and the W201P works normally.
3. Connecting the PoE cable to the W201P.
To power off the W140A, you just need to disconnect the PoE cable.
After power on, the W140A will start automatically, without any manual operation at
the management console.
2.5 Debugging
After the W140A is powered on and started, you should perform service debugging.
Service debugging serves the following three purposes:
1. Ensuring that the routes between the W140A and Internet/customer server are
smooth.
2. Ensuring that each client in the W140A coverage area can access the Internet
normally.
3. Ensuring that in the whole engineering coverage area, the clients can roam and
be handed over between the APs in different cells.
To Next Page
Loading...
