Zte ZXR10 - Command to Configure MAC Filter

Chapter Error! Style not defined. Error! Style not defined.
3-17
Parameter description:
Name Range Description
level-num
Lowest (Flood)
Lower (Info)
Higher (Error)
Highest (Fatal)
Level of the log print information to be output.
Only the information with a higher level will be
output.
3. logmsg mod-enable
Command mode: Configure mode
Function: Determine the module whose log print information should be output
Command format: wlan (config) # [no] logmsg mod-enable module
Parameter description:
Name Range Description
module A specified module name
Module whose log print information should be
output
4. logmsg telnet-log
Command mode: Configure mode
Function: Set the log print information output window to the active Telnet
window.
Command format: wlan (config) #[no] logmsg telnet-log
3.4.14 Command to Configure MAC Filter
Command mode: Configure mode
Function: Add/delete an access list by serial number
Command format: wlan
（
config
）
#[no] mac-access-list acl-list-number {deny|permit}
{macaddr|any}
Parameter description:
Name Range Description
acl-list-number 1~99 MAC filter group number
{ deny|permit } Deny, permit
Deny: If the conditions meet the requirements, the
MAC communication is denied.
Permit: If the conditions meet the requirements, the
MAC communication is allowed.