Chapter Error! Style not defined. Error! Style not defined.
2-11
2.2.5 Unpacking Inspection
Follow the steps below to perform unpacking inspection.
1. Checking outer packing conditions
If a package is obviously damaged, the technical personnel should mark the
damage distinctly and check the performance of the equipment in the package
afterwards.
2. Checking the amount of the packages
Check the amount of the packages against the packing list. For any discrepancy,
make a memo and report to the department concerned.
3. Unpacking
During the unpacking, handle the packages with care and protect the surface
coating in the parts. For any damage to the inner package materials, a detailed
record must be made.
All the part lists and technical documents of the W140A can be found in the
packing boxes. The installation personnel should check against the lists and read
the technical documents carefully.
4. Counting the articles
After unpacking, check the articles against the configuration list and packing list.
Make sure that the articles are all complete.
Note:
Unpacking inspection should be based on the packing list in the package. If there is any
missing part, please contact ZTE Cooperation.
2.3 Installation
2.3.1 Installation Process
Fig. 2.3-1 shows the process of installing the W140A.
To Next Page
Loading...
