Zte ZXR10 - Connecting Antenna Feeder; Connecting Poe Cable

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge
Professional Installation Instruction Manual
2-22
2.3.4 Connecting Antenna Feeder
To connect an antenna feeder cable, complete the following steps:
1. Attaching a shrinkable sleeve (for normal temperature) to the feeder cable.
2. Taking off the plastic dust-proof cover mounted on the W140A socket to the
feeder cable.
3. Plugging the feeder cable into the socket.
4. Fastening the feeder cable plug with the specified torque force (7 kgf/cm ~ 11.5
kgf/cm).
5. Attaching the shrinkable sleeve (for normal temperature) to the antenna
connector, and adjusting the sleeve.
When using the waterproof tape, you should bind the tape around the joints carefully,
wrap the outer cover with the insulting tape, and then apply the silica gel carefully.
Note:
● Never use the hot shrinkable sleeve.
● Observe the installation direction of the shrinkable sleeve (for normal
temperature). Make sure that it reaches the root of the connector post. Guidance is
required on how to use a shrinkable sleeve (for normal temperature).
● To fasten a feeder cable, you must use a torque wrench. Also, you must fasten the
cable with the specified torque, to make the feeder cable connector to be
waterproof.
2.3.5 Connecting PoE Cable
The W140A accepts power over Ethernet. The following steps describe how to connect
a PoE cable.
1. Making the Ethernet cable according to the engineering requirements
The W140A is accompanied with a 30m Ethernet cable. If a longer cable is
needed, you should make an Ethernet cable following the instructions for
making a standard straight-through cable. Please refer to Appendix A for details
of making an Ethernet cable.
Connect the manufactured Ethernet cable to the Ethernet cable originally in the