Zte ZXR10 - Privileged Mode; Command to Test Network Connectivity; Command to Save Configurations to Flash; Command to Reset Software

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge
Professional Installation Instruction Manual
3-4
3.3 Privileged Mode
Mode of entry: Type in the enable command in the in use mode and enter the correct
password.
Exit mode: disable for entering the user mode; exit for exiting the privileged mode and
go back to the system.
Default prompt: wlan#
3.3.1 Command to Test Network Connectivity
Command mode: privileged mode
Function: Test the network connectivity
Command format: ping A.B.C.D [-n echo-number] [-w timeout] [-l packet-size]
Parameter description:
Name Range Description
A.B.C.D IP address Destination IP address
-n Null Sets the flag bits for the number of PING packets
echo-number 1~40 The number of PING packets
-w Null Sets the flag bits for the maximum timeout interval
Timeout 1~2 Maximum timeout interval (unit: s)
-l Null Sets the flag bits for the capacity of buffer area
packet-size 0~1504 Capacity of buffer area
3.3.2 Command to Save Configurations to Flash
Command mode: privileged mode
Function: Save configurations to flash
Command format: wlan#write flash
3.3.3 Command to Reset Software
Command mode: privileged mode
Function: Reset W140A
Command format: wlan#reboot