Zte ZXR10 - Fig. 2.3-7 the Necessary Components in the Side Wall-Mounted Mode

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge
Professional Installation Instruction Manual
2-20
1
2
3
4
5
1. Omni antenna 2. Antenna stand kit 3. W140A 4. Installing support C 5. Backplane and mounting plane
Fig. 2.3-7 The Necessary Components in the Side Wall-Mounted Mode
To install an omni antenna in the side wall-mounted mode, follow the steps below:
1. Installing the antenna stand: Determine the installation location, and draw lines
at the two fastening holes in the wall fixture which is to used along with the
installing support. Then remove the wall fixture and drill holes (12 in diameter,
50 mm deep) at the marked places with an impact drill. After that, insert the
expansion bolts into the installation holes and fix the installing support to the
wall using the matched nuts. The installation spacing depends on the actual
situation.
2. Installing the antenna: Fix the antenna stand to the left and right locks in the
W140A using a U-shape fixture. Do not screw it too tight. Then fix the omni