ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge
Professional Installation Instruction Manual
3-2
7. The CLI provides two layers of password protection to reject illegal users. The
first layer password authentication appears on the Telnet welcome interface, then
the safety authentication for accessing the user mode is required. The default
user name is “root” and default password is “public”. In the user mode, input the
enable command and correct password to enter the privileged mode, the default
password is “zte”.
8. The CLI can automatically page the output commands on the terminal:
“—More—” at the lower left corner of the command output window indicates
more output commands. At this time, you can press CTRL to display the next
page, press ENTER to output the next line and press other keys to exit.
9. The W140A CLI provides the basic command line editing function. The
short-cut keys for editing command lines are described as follows:
Ctrl + U: Delete the whole command being input.
Ctrl + A: Move the cursor to the first character of the command line.
Ctrl + E: Move the cursor to the last character of the command line.
Ctrl + X: Delete all the characters before the cursor.
Ctrl + K: Delete all the characters after the cursor (containing the character at
the cursor)
Ctrl + C: Give up all the input contents. Enter the new line and the prompt
character will appear.
When the Telnet mode is used for configuring the W140A, you just need to input
“telnet working IP address of W140A”, as shown in Fig. 3.1-1. By default, the W140A
working IP address is 192.168.1.254 and the sub-network mask is 255.255.255.0.
To Next Page
Loading...
