Zte ZXR10 - Page 8

-ii-
3 Command Line Configuration .............................................................................................................. 3-1
3.1 Overview ....................................................................................................................................... 3-1
3.2 User Mode ..................................................................................................................................... 3-3
3.3 Privileged Mode ............................................................................................................................ 3-4
3.3.1 Command to Test Network Connectivity............................................................................ 3-4
3.3.2 Command to Save Configurations to Flash ........................................................................ 3-4
3.3.3 Command to Reset Software .............................................................................................. 3-4
3.3.4 Command to Enter Configure Mode................................................................................... 3-5
3.3.5 Command to Exit Privileged Mode .................................................................................... 3-5
3.3.6 Command to Exit TELNET Configuration......................................................................... 3-5
3.4 Configure Mode............................................................................................................................. 3-5
3.4.1 Commands to Configure Wireless Access-Bridge .............................................................. 3-5
3.4.2 Command to Configure Bridge Information....................................................................... 3-6
3.4.3 Commands to Configure DHCP Server .............................................................................. 3-7
3.4.4 Discover commands............................................................................................................ 3-8
3.4.5 Commands to Configure 802.1X Parameters ..................................................................... 3-9
3.4.6 Command to Set User Password in Privileged Mode ....................................................... 3-12
3.4.7 Command to Delete Filtration Rules ................................................................................ 3-12
3.4.8 Command to Exit Configuration Mode ............................................................................ 3-13
3.4.9 Commands to Configure IAPP (Load-balance) ................................................................ 3-13
3.4.10 Interface Skip.................................................................................................................. 3-14
3.4.11 Commands to Configure Layer 2 Isolation..................................................................... 3-15
3.4.12 Commands to Configure IP network Parameters............................................................ 3-15
3.4.13 Command to Configure Log Print Information .............................................................. 3-16
3.4.14 Command to Configure MAC Filter............................................................................... 3-17
3.4.15 Command to Configure MAC Address Authentication .................................................. 3-18