System date and time: The date and time are displayed in the lower right corner.
(2) Alarm display area
When there is an error message in the system, the error message or alarm
information will be displayed in the error message area. Click the alarm information to open
the alarm information details page.
◼ Function button
Contains multiple function buttons and shortcut buttons.
For opening each function page of the system, includes the following buttons:
1) Request: For sample test request, and support the functions of sample
information input, sample position setting, sample release and sample tray
scanning;
2) Result: View the test results, including historical results, and support editing
sample information, upload, printing, and deletion;
3) Reagent: Search reagent information, load or unload reagent, scan reagent
master calibration curve, calibration test request, consumables management
and other operations;
4) QC: Set up the parameters of the control, QC test request and search QC
results;
5) Alarm: Fault alarm, check alarm information and other operations;
6) Setting: Instrument IP settings, instrument setting, report settings, department
settings, user settings, etc.;
7) Maintenance: Unit module reset, instrument perfusion, manual trigger daily,
regular maintenance, diagnosis, log viewing and other operations.
◼ Control button
1) Start: Select the requested sample for testing;
2) Pause: Stop adding samples and reagents;
3) Stop: Stop all tests;
4) Shutdown: Exit the system normally according to the shutdown process.
◼ Function display area
The function interface displayed after clicking the function button.
To Next Page
Loading...