4.8.2.4.Item parameter
The system supports importing the default parameter list through an external file. If
an imported closed reagent item is no longer needed, it is allowed to delete the item
parameters by click [Delete] in [System Setting] - [Analyzer Setting]- [Item Parameter]
interface to delete it.
Make sure before deleting:
◼ The system is in a non-test state;
◼ The selected items are not used for sample, calibration and QC request and
testing;
◼ The configuration of selected item has been canceled;
◼ The selected reagent item has been unloaded from the reagent tray.
At the same time, the interface provides edit functions to edit basic information of project
parameters, and users can modify them according to actual usage.
Basic operation
◼ Item parameter scanning
1) Click [Scanning], a scanning box of item parameters will pop up;
2) Scan the QR code of the item information with an external barcode scanner;
3) Confirm that the item name is correct;
4) Click [OK].
◼ Edit parameter
Select the item to be modified in [Item List], and click [Save] after modifying the
item information.
◼ Delete item
Select the item to be deleted in [Item List] and click [Delete].
4.8.2.5.Item setting
The item configuration is used to configure and cancel the routine item that has set
various parameters correctly.
After the item configuration is canceled, it will not appear in all the places where the
item is needed.
Only after being configured, can the item participate in the request and test, and can
check its test results.
All items allow to configuration and to cancel configuration.
To Next Page