Chapter 7 WAN
NBG-418N v2 User’s Guide
84
Figure 59 Network > WAN > IPv6 (SLAAC/DHCPv6)
The following table describes the labels in this screen.
Address Autoconfiguration Settings
Enable
Autoconfiguration
Click Enable Autoconfiguration if you want the devices on your local area network to
obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration
Type
Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router
Advertisement
Lifetime
Type in the Router Advertisement Lifetime which is the amount of time in minutes
that a device may have an IPv6 address before it is required to renew the lease.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Table 33 Network > WAN > IPv6 (SLAAC/DHCPv6)
LABEL DESCRIPTION
IPv6 Connection
Type
Select SLAAC/DHCPv6 when your NBG-418N v2 requests an IPv6 address from the
ISP’s server.
IPv6 DNS Settings
Obtain DNS server
address
automatically
Click the Obtain DNS server address automatically radio button to get a DNS server
address from your ISP’s server.
Table 32 Network > WAN > IPv6 (continued)(Static IPv6)
LABEL DESCRIPTION
To Next Page
Loading...
