Chapter 7 WAN
NBG-418N v2 User’s Guide
85
Use the following
DNS address
Click Use the following DNS address radio button to use a fixed DNS address.
Primary and
Secondary DNS
Address
Enter the Primary and Secondary DNS address for the IPv6 server in the appropriate
box fields.
LAN IPv6 Address Settings
Enable DHCP-PD Click Enable DHCP-PD (DHCP-Prefix delegation) to allow NBG-418N v2 assign prefixes
to DHCP clients. The prefix is the part of the address that indicates the bits that have
fixed values or are the bits of the network identifier. Prefix is written in address/prefix-
length notation.
LAN IPv6 Address Enter the IPv6 IP address for the LAN port in this field.
LAN IPv6 Link-Local
Address
Enter the IPv6 Link-local address in the LAN side. This is used by routers when
communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Address Autoconfiguration Settings
Enable
Autoconfiguration
Click Enable Autoconfiguration if you want the devices on your local area network to
obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration
Type
Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router
Advertisement
Lifetime
Type in the Router Advertisement Lifetime which is the amount of time in minutes
that a device may have an IPv6 address before it is required to renew the lease.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Table 33 Network > WAN > IPv6 (continued)(SLAAC/DHCPv6)
LABEL DESCRIPTION
To Next Page
Loading...
