Chapter 10 Device HA
NWA3000-N Series User’s Guide
119
Virtual Router IP
/ Netmask
This is the interface’s IP address and subnet mask. Whichever device is the
master uses this virtual router IP address and subnet mask.
Managem ent I P /
Net mask
This field displays the interface’s management I P address and subnet mask. You
can use this IP address and subnet mask to access the device whether it is in
master or backup mode.
Link Status This tells whether the monitored interface’s connection is down or up.
HA Status The text before the slash shows whether the device is configured as the master or
the backup role.
This text after the slash displays the monitored interface’s status in the virtual
router.
Active - This interface is up and using the virtual IP address and subnet mask.
Stand-By - This interface is a backup interface in the virtual router. It is not using
the virtual IP address and subnet mask.
Fault - This interface is not functioning in the virtual router right now. In active-
passive mode (or in legacy mode with link monitoring enabled), if one of the
master device’s interfaces loses its connection, the master device forces all of its
interfaces to the fault state so the backup device can take over all of the master
device’s functions.
Apply Click Apply to save your changes back to the device.
Reset Click Reset to return the screen to its last-saved settings.
Table 44 Configuration > Device HA > General (continued)
LABEL DESCRIPTION
To Next Page
Loading...
