Chapter 17 File Manager
NWA3000-N Series User’s Guide
224
17.3 Firmware Package
Click Maintenance > File Manager > Firmw are Package to open this screen. Use the
Firm w are Package screen to check your current firmware version and upload firmware to the
device.
Note: The Web Configurator is the recommended method for uploading firmware. You
only need to use the command line interface if you need to recover the firmware.
See the CLI Reference Guide for how to determine if you need to recover the
firmware and how to recover it.
Find the firmware package at www.zyxel.com in a file that (usually) uses a .bin extension.
File Name This column displays the label that identifies a configuration file.
You cannot delete the following configuration files or change their file names.
The system -default.conf file contains the device’s default settings. Select this
file and click Apply to reset all of the device settings to the factory defaults. This
configuration file is included when you upload a firmware package.
The startup- config.conf file is the configuration file that the device is currently
using. If you make and save changes during your m anagement session, the
changes are applied to this configuration file. The device applies configuration
changes made in the Web Configurator to the configuration file when you click
Apply or OK. It applies configuration changes made via commands when you use
the write command.
The lastgood.conf is the most recently used (valid) configuration file that was
saved when the device last restarted. If you upload and apply a configuration file
with an error, you can apply lastgood.conf to return to a valid configuration.
When you change the device’s operation mode, it backs up the configuration to a
xxx-backup.conf file where xxx denotes the mode the NWA3000-N series AP was
previously using.
Size This column displays the size (in KB) of a configuration file.
Last Modified This column displays the date and time that the individual configuration files were
last changed or saved.
Upload
Configuration
File
The bottom part of the screen allows you to upload a new or previously saved
configuration file from your computer to your device
You cannot upload a configuration file named system -default.conf or
lastgood.conf.
If you upload startup-config.conf, it will replace the current configuration and
immediately apply the new settings.
File Path Type in the location of the file you want to upload in this field or click Brow se ...
to find it.
Browse... Click Brow se... to find the .conf file you want to upload. The configuration file
must use a “.conf” filename extension. You will receive an error message if you
try to upload a fie of a different format. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two
minutes.
Table 88 Maintenance > File Manager > Configuration File (continued)
LABEL DESCRIPTION
To Next Page
Loading...
