Chapter 15 System
NWA3000-N Series User’s Guide
193
The following table describes the labels in this screen.
15.6.5 Examples of Secure Telnet Using SSH
This section shows two examples using a command interface and a graphical interface SSH client
program to remotely access the device. The configuration and connection steps are similar for most
SSH client programs. Refer to your SSH client program user’s guide.
15.6.5.1 Example 1: Microsoft Windows
This section describes how to access the device using the Secure Shell Client program.
1 Launch the SSH client and specify the connection information (IP address, port number) for the
device.
2 Configure the SSH client to accept connection using SSH version 1.
3 A window displays prompting you to store the host key in you computer. Click Yes to continue.
Figure 92 SSH Example 1: Store Host Key
Enter the password to log in to the device. The CLI screen displays next.
Table 74 Configuration > System > SSH
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the device CLI
using this service.
Version 1 Select the check box to have the device use both SSH version 1 and version 2
protocols. I f you clear the check box, the device uses only SSH version 2 protocol.
Server Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Server
Certificate
Select the certificate whose corresponding private key is to be used to identify the
device for SSH connections. You must have certificates already configured in the
My Certificates screen.
Apply Click Apply to save your changes back to the device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
