Chapter 15 System
NWA3000-N Series User’s Guide
179
15.3.1 Pre-defined NTP Time Servers List
When you turn on the device for the first time, the date and time start at 2003-01-01 00: 00:00.
The device then attempts to synchronize with one of the following pre-defined list of Network Time
Protocol (NTP) time servers.
The device continues to use the following pre-defined list of NTP time servers if you do not specify a
time server or it cannot synchronize with the time server you specified.
When the device uses the pre-defined list of NTP time servers, it randomly selects one server and
tries to synchronize with it. If the synchronization fails, then the device goes through the rest of the
list in order from the first one tried until either it is successful or all the pre-defined NTP time
servers have been tried.
15.3.2 Time Server Synchronization
Click the Synchronize Now button to get the time and date from the time server you specified in
the Tim e Server Address field.
When the Loading message appears, you may have to wait up to one minute.
Figure 81 Loading
The Current Tim e and Current Date fields will display the appropriate settings if the
synchronization is successful.
If the synchronization was not successful, a log displays in the View Log screen. Try re-configuring
the Date/ Tim e screen.
To manually set the device date and time:
1 Click System > Date/ Tim e.
2 Select Manual under Time and Date Setup.
3 Enter the device’s time in the New Tim e field.
4 Enter the device’s date in the New Date field.
5 Under Tim e Zone Setup, select your Tim e Zone from the list.
6 As an option you can select the Enable Daylight Saving check box to adjust the device clock for
daylight savings.
7 Click Apply.
Table 71 Default Time Servers
0.pool.ntp.org
1.pool.ntp.org
2.pool.ntp.org
To Next Page
Loading...
