Chapter 6 Monitor
NWA3000-N Series User’s Guide
87
The following table describes the labels in this screen.
6.9 View Log
Log messages are stored in two separate logs, one for regular log messages and one for debugging
messages. In the regular log, you can look at all the log messages by selecting All Logs, or you can
select a specific category of log messages (for example, user). You can also look at the debugging
log by selecting Debug Log. All debugging messages have the same priority.
To access this screen, click Monitor > Log. The log is displayed in the following screen.
Note: When a log reaches the maximum number of log messages, new log messages
automatically overwrite existing log messages, starting with the oldest existing log
message first.
• For individual log descriptions, see Appendix A on page 255.
• For the maximum number of log messages in the device, see
Chapter 22 on page 251.
Table 30 Monitor > Wireless > Legacy Device Info
LABEL DESCRIPTION
Device IP
Address
Enter the legacy AP’s IP address.
Description Enter a description to help you identify the legacy AP.
OK Click OK to save your changes back to the device.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
