Chapter 6 Monitor
NWA3000-N Series User’s Guide
88
Events that generate an alert (as well as a log message) display in red. Regular logs display in
black. Click a column’s heading cell to sort the table entries by that column’s criteria. Click the
heading cell again to reverse the sort order.
Figure 31 Monitor > Log > View Log
The following table describes the labels in this screen.
Table 31 Monitor > Log > View Log
LABEL DESCRIPTION
Show Filter /
Hide Filter
Click this button to show or hide the filter settings.
If the filter settings are hidden, the Display, Email Log Now, Refresh, and
Clear Log fields are available.
If the filter settings are shown, the Display, Priority, Source Address,
Destination Address, Service, Keyw ord, and Search fields are available.
Display Select the category of log message(s) you want to view. You can also view All
Logs at one time, or you can view the Debug Log.
Priority This displays when you show the filter. Select the priority of log messages to
display. The log displays the log messages with this priority or higher. Choices
are: any, em erg, alert, crit, error, w arn, notice, and info, from highest
priority to lowest priority. This field is read-only if the Category is Debug Log.
Source Address This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
Destination
Address
This displays when you show the filter. Type the IP address of the destination of
the incoming packet when the log message was generated. Do not include the
port in this filter.
To Next Page
Loading...
