Chapter 6 Monitor
NWA3000-N Series User’s Guide
89
The Web Configurator saves the filter settings if you leave the View Log screen and return to it
later.
Source Interface This displays when you show the filter. Select the source interface of the packet
that generated the log message.
Destination
Interface
This displays when you show the filter. Select the destination interface of the
packet that generated the log message.
Keyword This displays when you show the filter. Type a keyword to look for in the
Message, Source, Destination and Note fields. If a match is found in any field,
the log message is displayed. You can use up to 63 alphanumeric characters and
the underscore, as well as punctuation marks ()’ ,:; ?! + -* / = # $% @ ; the period,
double quotes, and brackets are not allowed.
Protocol This displays when you show the filter. Select a service protocol whose log
messages you would like to see.
Search This displays when you show the filter. Click this button to update the log using
the current filter settings.
Email Log Now Click this button to send log messages to the Active e-mail addresses specified in
the Send Log To field on the Log Settings page.
Refresh Click this to update the list of logs.
Clear Log Click this button to clear the whole log, regardless of what is currently displayed
on the screen.
# This field is a sequential value, and it is not associated with a specific log
message.
Time This field displays the time the log message was recorded.
Priority This field displays the priority of the log message. It has the same range of values
as the Priority field above.
Category This field displays the log that generated the log message. It is the same value
used in the Display and (other) Category fields.
Message This field displays the reason the log message was generated. The text
“[ count= x] ”, where x is a number, appears at the end of the Message field if log
consolidation is turned on and multiple entries were aggregated to generate into
this one.
Source This field displays the source IP address and the port number in the event that
generated the log message.
Destination This field displays the destination IP address and the port number of the event
that generated the log message.
Note This field displays any additional information about the log message.
Table 31 Monitor > Log > View Log (continued)
LABEL DESCRIPTION
To Next Page
Loading...
