Chapter 11 User
NWA3000-N Series User’s Guide
132
11.3.1 Edit User Authentication Timeout Settings
This screen allows you to set the default authentication timeout settings for the selected type of
user account. These default authentication timeout settings also control the settings for any
existing user accounts that are set to use the default settings. You can still manually configure any
user account’s authentication timeout settings.
User Type These are the kinds of user account the device supports.
• admin - this user can look at and change the configuration of the
device
• lim ited-admin - this user can look at the configuration of the
device but not to change it
• user - this is used for embedded RADIUS server and SNMPv3 user
access
Lease Time This is the default lease time in minutes for each type of user account.
It defines the number of minutes the user has to renew the current
session before the user is logged out.
Adm in users renew the session every time the main screen refreshes
in the Web Configurator.
Reauthentication Time This is the default reauthentication time in minutes for each type of
user account. It defines the number of minutes the user can be logged
into the device in one session before having to log in again. Unlike
Lease Tim e, the user has no opportunity to renew the session without
logging out.
User Logon Settings
Limit the number of
simultaneous logons for
administration account
Select this check box if you want to set a limit on the number of
simultaneous logins by admin users. If you do not select this, admin
users can login as many times as they want at the same time using the
same or different IP addresses.
Maximum number per
administration account
This field is effective when Limit ... for adm inistration account is
checked. Type the maximum number of simultaneous logins by each
admin user.
User Lockout Settings
Enable logon retry limit Select this check box to set a lim it on the number of times each user
can login unsuccessfully (for example, wrong password) before the IP
address is locked out for a specified amount of time.
Maximum retry count This field is effective when Enable logon retry limit is checked. Type
the maximum number of times each user can login unsuccessfully
before the IP address is locked out for the specified lockout period.
The number must be between 1 and 99.
Lockout period This field is effective when Enable logon retry lim it is checked. Type
the number of minutes the user must wait to try to login again, if
logon retry limit is enabled and the m axim um retry count is
reached. This number must be between 1 and 65,535 (about 45.5
days).
Apply Click Apply to save the changes.
Reset Click Reset to return the screen to its last-saved settings.
Table 50 Configuration > Object > User > Setting (continued)
LABEL DESCRIPTION
To Next Page
Loading...
