Chapter 11 User
NWA3000-N Series User’s Guide
133
To access this screen, go to the Configuration > Object > User > Setting screen, and click one
of the Default Authentication Timeout Settings section’s Edit icons.
Figure 60 User > Setting > Edit User Authentication Timeout Settings
The following table describes the labels in this screen.
Table 51 User > Setting > Edit User Authentication Timeout Settings
LABEL DESCRIPTION
User Type This read-only field identifies the type of user account for which you are
configuring the default settings.
• admin - this user can look at and change the configuration of the device
• lim ited-adm in - this user can look at the configuration of the device but
not to change it
• user - this user has access to the device’s services but cannot look at the
configuration
Lease Time Enter the number of minutes this type of user account has to renew the current
session before the user is logged out. You can specify 1 to 1440 minutes. You
can enter 0 to make the number of minutes unlimited.
Adm in users renew the session every time the main screen refreshes in the
Web Configurator. Access users can renew the session by clicking the Renew
button on their screen. If you allow access users to renew time automatically,
the users can select this check box on their screen as well. In this case, the
session is autom atically renewed before the lease time expires.
Reauthentication
Time
Type the number of minutes this type of user account can be logged into the
device in one session before the user has to log in again. You can specify 1 to
1440 minutes. You can enter 0 to make the number of minutes unlimited.
Unlike Lease Time, the user has no opportunity to renew the session without
logging out.
OK Click OK to save your changes back to the device.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
