Chapter 15 System
NWA3000-N Series User’s Guide
203
15.10.2 Adding or Editing a Trusted AP Profile
This screen allows you to add or edit an internal RADIUS server trusted AP profile. To access this
screen, click the Configuration > System > Auth. Server screen’s Add button or select a trusted
AP profile from the list and click the Edit button.
Figure 102 Configuration > System > Auth. Server > Add
The following table describes the labels in this screen.
Apply Click OK to
save your changes back to the device.
Reset Click Reset to start configuring this screen afresh.
Table 80 Configuration > System > Auth. Server (continued)
LABEL DESCRIPTION
Table 81 Configuration > System > Auth. Server
LABEL DESCRIPTION
Activate Select this to turn on this trusted AP profile.
Profile Name Type a name for the trusted AP profile.
IP Address Type the IP address of the trusted AP in dotted decimal notation.
Netmask Type the subnet mask of the trusted AP in dotted decimal notation. The subnet
mask indicates what part of the IP address is the same for all computers in the
network.
Secret Enter a password (up to 31 alphanumeric characters, no spaces) as the key for
encrypting comm unications between the device and this entry’s AP. The key is
not sent over the network. This key m ust be the same on the device and the AP.
Both the device’s IP address and this shared secret must also be configured in
the “external RADIUS” server fields of the trusted AP.
Description Type some information to help identify the trusted AP.
OK Click OK to save your changes back to the device.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
