Chapter 15 System
NWA3000-N Series User’s Guide
196
To change your device’s FTP settings, click Configuration > System > FTP tab. The screen
appears as shown. Use this screen to specify FTP settings.
Figure 96 Configuration > System > FTP
The following table describes the labels in this screen.
15.9 SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your device supports SNMP agent functionality, which allows a manager
station to manage and monitor the device through the network. The device supports SNMP version
Table 76 Configuration > System > FTP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the device
using this service.
TLS required Select the check box to use FTP over TLS (Transport Layer Security) to encrypt
communication.
This implements TLS as a security mechanism to secure FTP clients and/ or
servers.
Server Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Server
Certificate
Select the certificate whose corresponding private key is to be used to identify the
device for FTP connections. You must have certificates already configured in the
My Certificates screen.
Apply Click Apply to save your changes back to the device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
