Chapter 16 Log and Report
NWA3000-N Series User’s Guide
207
The following table describes the labels in this screen.
16.3 Log Setting
These screens control log messages and alerts. A log message stores the information for viewing
(for example, in the View Log tab) or regular e-mailing later, and an alert is e-mailed immediately.
Usually, alerts are used for events that require more serious attention, such as system errors and
attacks.
The device provides a system log and supports e-mail profiles and remote syslog servers. The
system log is available on the View Log tab, the e-mail profiles are used to mail log messages to
the specified destinations, and the other four logs are stored on specified syslog servers.
The Log Setting tab also controls what information is saved in each log. For the system log, you
can also specify which log messages are e-mailed, where they are e-mailed, and how often they are
e-mailed.
For alerts, the Log Settings tab controls which events generate alerts and where alerts are e-
mailed.
Table 82 Configuration > Log & Report > Email Daily Report
LABEL DESCRIPTION
Enable Email
Daily Report
Select this to send reports by e-mail every day.
Mail Server Type the name or IP address of the outgoing SMTP server.
Mail Subject Type the subject line for the outgoing e-mail. Select Append system nam e to add
the device’s system name to the subject. Select Append date tim e to add the
device’s system date and time to the subject.
Mail From Type the e-mail address from which the outgoing e-m ail is delivered. This address
is used in replies.
Mail To Type the e-mail address (or addresses) to which the outgoing e-mail is delivered.
SMTP
Authentication
Select this check box if it is necessary to provide a user name and password to the
SMTP server.
User Name This box is effective when you select the SMTP Authentication check box. Type
the user name to provide to the SMTP server when the log is e-mailed.
Password This box is effective when you select the SMTP Authentication check box. Type
the password to provide to the SMTP server when the log is e-mailed.
Send Report
Now
Click this button to have the device send the daily e-mail report immediately.
Time for
sending report
Select the time of day (hours and minutes) when the log is e-mailed. Use 24-hour
notation.
Report Items Select the information to include in the report. Select Reset counters after
sending report successfully if you only want to see statistics for a 24 hour
period.
Reset All
Counters
Click this to discard all report data and start all of the counters over at zero.
Apply Click Apply to save your changes back to the device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
