Chapter 15 System
NWA3000-N Series User’s Guide
194
15.6.5.2 Example 2: Linux
This section describes how to access the device using the OpenSSH client program that comes with
most Linux distributions.
1 Test whether the SSH service is available on the device.
Enter “telnet 192.168.1.2 22” at a terminal prompt and press [ENTER]. The computer
attempts to connect to port 22 on the device (using the default IP address of 192.168.1.2).
A message displays indicating the SSH protocol version supported by the device.
Figure 93 SSH Example 2: Test
2 Enter “ssh –1 192.168.1.2”. This command forces your computer to connect to the device using
SSH version 1. If this is the first time you are connecting to the device using SSH, a message
displays prompting you to save the host information of the device. Type “yes” and press [ENTER].
Then enter the password to log in to the device.
Figure 94 SSH Example 2: Log in
3 The CLI screen displays next.
$ telnet 192.168.1.2 22
Trying 192.168.1.2...
Connected to 192.168.1.2.
Escape character is '^]'.
SSH-1.5-1.0.0
$ ssh –1 192.168.1.2
The authenticity of host '192.168.1.2 (192.168.1.2)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.2' (RSA1) to the list of known hosts.
Administrator@192.168.1.2's password:
To Next Page
Loading...
