Chapter 22 Product Specifications
NWA3000-N Series User’s Guide
254
3 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm between the
heads of the screws and the wall.
4 Make sure the screws are snugly fastened to the wall. They need to hold the weight of the device
with the connection cables.
5 Align the holes on the back of the device with the screws on the wall. Hang the device on the
screws.
Figure 120 Wall-mounting Example
The following are dimensions of an M4 tap screw and masonry plug used for wall mounting. All
measurements are in millimeters (mm).
Figure 121 Masonry Plug and M4 Tap Screw
To Next Page
Loading...
