Chapter 4 Tutorials
NWA3000-N Series User’s Guide
65
1 Click Configuration > W ireless > DCS.
2 Select Enable Dynam ic Channel Selection to turn on this feature.
3 Set the DCS Tim e I nterval. This is how often the device surveys the other APs within its broadcast
radius. If you place your APs in an area with a large number of competing APs, set this number
lower to ensure that your device can adjust quickly changing conditions.
4 Select DCS Sensitivity Level. This is how sensitive the APs on your network are to other channels.
Generally, as long as the area in which your AP is located has minimal interference from other
devices you can set the DCS Sensitivity Level to Low. This means that the AP has a very broad
tolerance.
5 Select Enable DCS Client Aw are. Select this so that the APs on your network do not change
channels as long as any wireless clients are connected to them. When they must change channels,
they will wait until all stations disconnect first.
6 Set the 2 .4-GHz Channel Selection Method to auto.
7 Select a 2.4 GHz Channel Deploym ent scheme. Choose Three-Channel Deployment to have
the device rotate through 3 channels. Choose Four-Channel Deployment to have the device
rotate through 4 channels, if allowed.
8 Click Apply to save your changes.
See also:
Chapter 9 on page 101.
To Next Page
Loading...
