Chapter 7 Management Mode
NWA3000-N Series User’s Guide
96
Click Configuration > MGNT MODE in the device’s navigation menu. The following screen
displays.
Figure 35 Configuration > MGNT MODE
The following table describes the labels in this screen.
Table 33 Configuration > MGNT MODE
LABEL DESCRIPTION
AP Controller Select this option to have the device act as a managing device for other
devices on your network. The device only acts as a controller when you
select this. Wireless clients cannot connect directly to the controller; you
have to connect to it through the wired network.
Standalone AP Select this to manage the device using its own web configurator, neither
managing nor managed by other devices.
Managed AP Select this to have the device managed by another device on your
network.
When you do this, the device can be configured ONLY by the management
AP. If you do not have an AP controller on your network and want to
return the device to standalone mode, you m ust use the its physical
RESET button or the commands. All settings are returned to their default
values.
Apply Click this to save your changes.
If you change the mode in this screen, the device restarts. Wait a short
while before you attempt to log in again. If you changed the mode to
Managed AP, you cannot log in as the web configurator is disabled; you
must manage the device through the controller AP on your network.
Reset Click this to return this screen to its previously-saved settings.
To Next Page
Loading...
